Sets the highest preset the controller can access. Set to 0 to disable preset mode.
Sets the lowest preset the controller can access.
Must be less than Max Preset.
Device channels preset mode. Defaults to A B C.
Sets the number of device pages shown.
Sets the device driver for the A device, on channel 1.
Turns on the preset name display.
(LED4 version will scroll name).
Display Brightness.
Controls how the Preset Mode display will show.
Set to 0-99 for normal behaviour or 1-100 if your controller starts with program 1
Sets the input channel for the DMC.micro itself, allows external devices to control the DMC.
Sets the output channel for Auto Config, used for controlling other Disaster Area gear.
May also be used as a fifth MIDI output channel.
Controller will send a MIDI program change message on this channel matching the main preset number.
Configures MIDI thru for each interface on the DMC.micro.
Enabled interfaces will pass incoming data to all other ports.
USB HOST Thru requires HOST set to INPUT, not supported on Gen3.
Sets the MIDI channels used for DevA - DevD
Configures the USB port.
A reboot is required after this setting is changed.
Sets the function of the MultiJack connector.
UTIL FS will enable the JACK TIP and JACK RING configuration options.
Sets the device channels the MultiJack will use to send data.
Check to save and recall the states of the X, Y, and/or JACK UTIL functions.
Any functions on the associated channels that are set to TOGGLE will be sent on preset load.
User defined mode, sends up to three different MIDI messages
Enable or disable Util Mode X
Enable or disable Util Mode Y or select Looper mode for a device.
Lowest number program to access on Custom Device 1.
Highest number program to access on Custom Device 1.
Bypass CC for Custom Device 1.
Tap tempo CC for Custom Device 1.
Expression control CC for Custom Device 1.
Display style for Custom Device 1.
Lowest number program to access on Custom Device 2.
Highest number program to access on Custom Device 2.
Bypass CC for Custom Device 2.
Tap tempo CC for Custom Device 2.
Expression control CC for Custom Device 2.
Display style for Custom Device 2.
Enable or disable CLOCK mode.
NO CLOCK disables clock mode.
Preset Clock mode sends a saved tempo for each preset load.
Global tempo sends the same tempo for all presets.
Preset Clock (4 taps) sends 4 taps on each preset load.
Global (4 taps) sends 4 taps when the user taps in a new tempo
Sets the duration of the tap length for MultiJack N-O or N-C modes. Does not apply for any other MultiJack settings or for MIDI clock.
Enable or disable MIDI clock sending on each MIDI interface.
Sets the hold time for the device footswitches. Set this to SHORT for faster hold operation, or to LONG to prevent accidental holds
Long-hold right footswitch to jump to this mode
If the selected mode is disabled the controller will jump to the next available mode
Configure how the controller sends bypass commands.
ON CHANGE sends only if a new preset has a different bypass state to the current preset.
ALWAYS will send on every preset load.